Speco Technologies & IP-WDRB1 Uživatelský manuál stáhnout pdf (Strana 14)

IP Camera User’s Manual Speco Technologies

2. Install and Check Video

2.1. Installation

1) Connect the IP Camera to the PC by LAN cable (Crossover Cable)

2) Supply power to the camera using a 12 volt DC regulated power supply.

3) Wait approximately 2 minutes until the Link/LED light comes on.

2.2. Video Check

Basic network setting value of the camera is to be:

 IP Address: 192.168.1.7

 Subnet Mask: 255.255.255.0

 Gateway: 192.168.1.1

To connect THE CAMERA into the user’s PC, change the setting value of the PC network

environment.

Fig. 2―1 Network Setting of User PC

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 125 126

IP Camera User’s Manual 1
Important Notes 3
1. Feature 7
1. Feature 8
1.2.1. Dimensions 9
3) Traditional Camera 10
3) Speed Dome Camera 10
1.2.2. Camera Feature 11
III. WDR Camera 12
2. Install and Check Video 13
2. Install and Check Video 14
3. Basic Setting 18
3. Basic Setting 19
3.2.1. Static IP Setup 20
3.2.2. Dynamic IP Setup 23
3.4. Cautions 29
4. Expert Setting 30
4. Expert Setting 31
4.1. General Setting 33
4.1.3. User Registration 34
4.1.4. User List and Delete 35
4.1.6. Time Zone Setting 36
4.2. Network Setting 37
4.3. Video Setting 38
4.4. Color Setting 39
4.5. Alarm Setting 39
4.5.2. Alarm Event Test 41
4.7. Motion Area Setup 42
4.9. Homepage Update 44
4.10. Firmware Update 44
4.10.1. Remote Upgrade 45
4.10.2. System Re-booting 47
4.11. Factory Reset 48
5. Basic Use 49
5. Basic Use 50
5.2.1. Function 53
3) WDR Camera (IP-WDRB1) 55
5.2.2. OSD Menu Setting 56
③When completed, press ‘SET’ 62
3) AUTO GAIN CONTROL (AGC) 64
E) REVERSE 74
G) DEFAULT 76
H) PAGE1 76
OSD MENU CONTROL 77
OSD MENU ENTER / EXIT 77
MAIN MENU 77
A. Dome Setup 80
left” to 80
B. CAMERA SET 85
 Indoor – up to 3,200°K 86
 Outdoor – up to 5,800°K 86
C. PRESET SET 87
D. AUTO SCAN SET 88
E. TOUR SET 90
F. PRIVACY SET 91
G. PATTERN SET 92
H. ALARM SET 94
I. SECTOR SET 95
J. EXIT 96
DIP SW SETTING 97
PROTOCOL 98
5.2.9. BAUD RATE SETTING 98
5.4. Use of Service Server 101
5.4.1. User Registration 102
5.4.2. Camera Registration 104
5.4.3. List of Camera 105
5.4.5. Search Camera 108
5.5.1. WAP2.0 (HTML) 109
5.5.2. PDA(WinCE) 112
5.6. Use of NVR Program 113
6. Network Environment 114
6. Network Environment 115
7. Appendix 117
7. Appendix 118
B-6 IP-SD10X 124

Komentáře k této Příručce

Žádné komentáře

Speco Technologies & IP-WDRB1 Uživatelský manuál Strana 14

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní kamery Speco Technologies & IP-WDRB1